(25) Fit the Logosol extender
nuts through the chain-saw
plate using the front hole. (For
some chain-saw models the
rear hole has to be used to
ensure that the saw cover will
not extend too far. However, this
is relatively unusual.) Screw the
chain-saw’s guide bar nuts onto
the Logosol extender nuts under
the plate and tighten.
25
26
27
(26) Fit the chain guard support
on the two arms of the chain-
saw plate so that the chain
guard sits app. 4 cm (1 1/2”)
from the tip of the guide bar. (2 x
M6x40 bolts, 2 x M6 collar nuts)
(27) Push the assembled
carriage onto the guide rail with
the guide bar facing the log
beds.
Check that the carriage
moves easily on the guide
rail. If not, loosen the eight bolts
holding the sliding rails, move
the carriage back and forth and
retighten the eight bolts. If this is
insufficient, check the plastic
slide rails for damage.
Assembly: chain-saw
17
