A SERVICE OF

logo

Open as PDF
next previous
3.
Remove the solid-state drive (3) from the solid-state drive bay.
4. If it is necessary to disassemble the solid-state drive, perform the following steps:
a.
Remove the four Phillips PM3.0×3.0 screws (1) that secure the hard drive bracket to the
solid-state drive.
b. Remove the hard drive bracket (2) from the solid-state drive. The hard drive bracket and
screws are available in the Hard Drive Hardware Kit, spare part number 642774-001.
Reverse this procedure to reassemble and install the solid-state drive.
Component replacement procedures
33