A SERVICE OF

logo

Power cords
The po w er cor d se
t must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in
that country.
The po wer cord mu
st be rated for the product and for the voltage and current marked on the product
electrical rat
ings label. The voltage and current rating of the cord should be greater than the voltage and
current rating
marked on the product. In addition, the diameter of the wire must be a minimum of 1.00
mm
2
or 18 AWG, a
nd the length of the cord must be bet ween 1.8 m (6 ft) and 3.6 m (12 ft). If you have
questions ab
out the type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay pa rticular attention to the plug, electrical outlet, a nd the point where the cords
exit from the pr oduct.
Japanese power cord statement
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
45