50 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
▼ To Log Into the Service Processor Using the
Network Management Port
Note – You must configure the service processor parameters shown in “To
Configure the Service Processor Network Management Port” on page 47 before you
can use the network management port.
● Open an SSH session and connect to the service processor by specifying its
network address.
Using the Service Processor for Common
Operations
Note – For more information on using the ILOM service processor, refer to the
Integrated Lights Out Manager 2.0 Supplement for SPARC Enterprise T5140 and T5240
Servers.
% ssh root@xx.xxx.xx.x
...
Are you sure you want to continue connecting (yes/no)? yes
...
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Integrated Lights Out Manager
Version 2.0.0.0
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
->
