Type ‘n Speak 2000
For your Type ‘n Speak 2000, the disk drive is packaged with
the DDA2-TNS-1 cable.
Connect the cable’s small round end to the 6-pin port on the
backside of the notetaker. This should be the second port from
the right side. The connector is keyed so that it will plug in only
one way and it should slide in easily.
Braille ‘n Speak 2000 and Braille Lite 2000
For your Braille ‘n Speak and Braille Lite 2000, the disk drive
is packaged with the DDA2-BNS-2 cable.
Connect the cable’s small round end to the 8-pin port on the
left side of the notetaker. On these notetakers it does not
matter which port you use. The connector is keyed so that it
will plug in only one way and it should slide in easily.
Braille Lite 40 and Braille Lite M20
For your Braille Lite 40 and Braille Lite M20, the disk drive is
packaged with the DDA2-BNS-2 cable.
Connect the cable’s small round end to the 8-pin port on either
side of the notetaker. On these notetakers it does not matter
which port you use. The connector is keyed so that it will plug
in only one way and it should slide in easily.
Type Lite and Braille Lite M40
For your Type Lite and Braille Lite M40, the disk drive is
packaged with the DDA2-BNS-2 cable.
Connect the cable’s small round end to the 8-pin port on the
backside of the notetaker. On the bottom side of the Type Lite,
the correct port is indicated in Braille as dd. On the Braille Lite
M40, the correct pair of ports to use are located just right of
2 Part # 440057-001 Rev. A
