PA 300 Peaking Amplier • Installation and Operation
2-5
1. Remove two screws from one side of the unit. Retain the
screws for possible future use.
2. Attach one bracket to the side of the unit, using the
provided machine screws.
3. Repeat steps 1 and 2 on the other side of the unit.
4. Hold the PA 300 with the attached brackets against the
mounting location. On the mounting surface, mark the
location of the four bracket screw holes.
5. Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm)
in diameter in the desk or table at the locations of the
mounting bracket screws. The holes should be drilled
from the underside or inside (concealed side) of the
furniture, where the amplifier will be located.
6. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
7. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
8. Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
