PA 300 Peaking Amplier • Installation and Operation
2-3
Tabletop use
Four self-adhesive rubber feet are included with the PA 300.
For tabletop use, affix one foot at each corner of the bottom side
of the unit and place the unit in the desired location.
Rack mounting
For optional rack mounting, do not install the rubber feet.
Mount the PA 300 on a 6" deep, 1U high rack shelf (part
#60-190-10 or 60-604-10) or a 9.5" deep 1U high rack shelf (part
#60-190-01 or 60-604-01).
1. Remove the rubber feet if they were previously installed
on the bottom of the unit.
2. Mount the unit on the rack shelf, using two 4-40 x 3/16"
screws in opposite (diagonal) corners to secure it.
3. Install blank panel(s) or other unit(s) on the rack shelf.
4. Attach the rack shelf to the rack using the supplied bolts.
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
Mounting the PA 300 on a 6-inch deep rack shelf
