Through-deskMounting
Mount the switcher through a desk or podium as follows:
1. Attach the mounting brackets to the switcher
with themachine screws provided.
2. Cut the proper sized hole in themounting
surface.
3. Hold the switcher with the attached brackets
against the underside of the table or other
furniture. Mark the location of the screw
holes of the bracket on themounting surface.
4. Drill 3/32 inch (2mm) diameter pilot holes,
1/4inch (6.4mm) deep in themounting
surface at themarked screw locations.
5. Insert four #8 wood screws through the
bracket and into the four pilot holes. Tighten
all four screws to secure the switcher in
place.
MPS601 • Reference Information 46
