RackMounting
w
e
Washer
Figure 38. Mounting the Switcher
Table or WallMounting
The table or wallmounting brackets extend approximately 1/4 inch (6.4mm) above the top
surface of the switcher enclosure allowing for an air space between the enclosure and the
surface. Table or wallmount the switcher as follows:
1. Attach the table or wallmounting brackets to the switcher with the eight #8machine
screws (figure 37 on page 44).
2. Hold the switcher with the attached brackets against the underside of the table or other
furniture, or against the wall. Mark the location of the screw holes of the bracket on
themounting surface.
3. Drill 3/32 inch (2mm) diameter pilot holes, 1/4 inch (6.4mm) deep in themounting
surface at themarked screw locations.
4. Insert #8 wood screws into the four pilot holes. Tighten each screw into themounting
surface until just less than 1/4 inch of the screw’s head protrudes.
5. Align themounting screws with the slots in the brackets and place the switcher against
the surface, with the screws through the bracket slots.
6. Slide the switcher slightly forward or back, then tighten all four screws to secure the
switcher in place.
MPS601 • Reference Information 45
