MDA 4V HD-SDI and SDI User's Guide • Introduction
MDA 4V HD-SDI and SDI User's Guide
6
MDA 4V HD-SDI and SDI User's Guide • Introduction
7
MDA 4V HD-SDI and SDI User's Guide • Installation
MDA 4V HD-SDI and SDI User's Guide • Installation
M
A
V
S
E
R
IE
S
AV
MA
TRIX SWITCHER
I/O
A
U
D
A
U
D
I
O
S
E
T
U
P
P
R
E
S
E
T
V
I
D
I
R
+dB
-
dB
E
N
T
E
R
2
7
6
5
2
4
1
IN
P
U
T
S
O
U
T
P
U
T
S
8
3
1
8
6
5
4
3
7
Rear
Front
Figure 6 — Typical back of the rack installations
Furniture mounting
Furniture mount the MDA using the optional MBU VersaTools
under desk mounting kit (part #70-212-01) as follows:
1. Attach the mounting brackets to the MDA with the
provided machine screws (figure 7).
Figure 7 — Under-desk mounting the MDA
2. If feet were previously installed on the bottom of the MDA,
remove them.
3. Hold the MDA with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
6. Align the mounting screws with the slots in the brackets
and place the MDA against the surface, with the screws
through the bracket slots.
7. Slide the MDA slightly forward or back, then tighten all
four screws to secure the MDA.
