Installation and Operation, cont’d
VersaTools
®
MDA EQ Series • Installation and Operation VersaTools
®
MDA EQ Series • Installation and Operation
2-4 2-5
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
Mounting an MDA EQ on a 6-inch rack shelf
Furniture mounting
To furniture-mount the MDA EQ, use the optional MBU 123
mini under-desk mounting kit (part #70-212-01), as follows.
Preparing the MDA EQ for under-desk mounting
1. If rubber feet were previously attached to the bottom of the
unit, remove them.
2 Attach the mounting brackets to the MDA EQ with the
provided machine screws as shown in the previous figure.
3. Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
4. Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
in the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7. Slide the unit slightly forward or back, then tighten all
four screws to secure it in place.
Projector mounting
To projector-mount the MDA EQ, use one of the optional
mounting kits described in the following sections.
PMK 100 Mini Projector Mounting Kit
The PMK 100 is a projector mounting kit (part #70-217-01)
designed for use with Extron 1U high, quarter-rack width
products like the VersaTools products. It allows them to be
mounted near or on a projector support.
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Projector-mounting the MDA EQ using the
PMK 100 Projector Mounting Kit
Follow these steps to projector-mount the MDA EQ using the
PMK 100 kit:
1. If rubber feet are attached to the bottom of the MDA EQ,
remove them.
