DXP DVI, DXP DVI Pro, and DXP HDMI Series • Matrix Software 79
IP Setup
The IP Settings/Options window lets you view and, if connected via the RS-232 or
RS-422 link or logged on via the Ethernet port as an administrator, edit settings unique to
the Ethernet interface. To display the IP Settings/Options window, select IP Options from
the Tools pull-down menu.
Figure 79. IP Settings/Options Window
ATTENTION: Editing the following elds or check boxes on the IP Settings/Options
screen while connected via the Ethernet port can immediately
disconnect your computer from the switcher:
• Matrix IP Address
• Gateway IP Address
• Subnet Mask
• Use DHCP check box
• Administrator Password
NOTES: • Extron recommends editing the settings on this screen using the RS-232 or
RS-422 link and protecting the Ethernet access to this screen by assigning
an administrator password to qualified and knowledgeable personnel only.
• When the control program is connected to the DXP via RS-232 or RS-422,
the Administrator Password and User Password fields are not masked. If
a password has been inadvertently changed to an unknown value, you can
look up and, if desired, change a password in this window without knowing
the current password.
See “IP Addressing” on page 125 for basic information about IP addresses.
