A SERVICE OF

logo

3 - 12 Document #98210104
Step 2
Attach the chain to the end rail tie on the front
and back. Secure the chains with
1
/
2
lock
washers and nuts.
Step 3
Assemble the C-channel Cross Brace with
3
/
8
”x1” bolts, but don’t tighten them down yet.
Step 4
Place the two assembled cross members in the
pit. See Figure 6 in Appendix A.
Note: Move the dyno back and forth from front to
back. The dyno should not touch the cross
members, if it does, you’ll need to move the
cross members for clearance.