Turn on the XNAV3550. From the main menu, tap the NAVI icon. The
navigation software will load in approximately 10 seconds. The first
time you select the NAVI icon a brief introduction will appear.
Tap the right triangle to advance to
the next page or tap the
button
to quit the introduction and proceed
to the warning screen.
Tap the
. If you tap
the
button, the unit will
return to the main menu. If you
tap
, the main navigation
screen will appear.
Tap
to immediately
begin viewing your current location
on the map, or, tap
to
begin navigating. Use the Zoom
in/Zoom out key on the right side of
the unit to adjust the map view.
The GPS signal status icon in the middle right must be green to
show your current location on the map or to begin navigation.
When you start NavAtlas Navigator, it shows the last screen that
was displayed when NavAtlas Navigator was last turned off. You may
easily access the main navigation screen from any other screen by
tapping the
button.
