152
24
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
create arpentry <ipaddr> <macaddr>
config arpentry <ipaddr> <macaddr>
delete arpentry {[<ipaddr> | all]}
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | [static | local]}
config arp_aging time <value 0-65535>
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description This command is used to enter an IP address and the corresponding
MAC address into the switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To create a static arp entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DES-3550:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DES-3550:4#
config arpentry
Purpose Used to configure a static entry in the ARP table.
Syntax
config arpentry <ipaddr> <macaddr>
Description This command is used to configure a static entry in the ARP Table.
The user may specify the IP address and the corresponding MAC
