129
config radius add
Description
The
config radius add
command is used to configure the settings
the switch will use to communicate with a RADIUS server.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the switch and the Radius server.
<passwd 32> − The shared-secret key used by the RADIUS server
and the switch. Up to 32 characters can be used.
default − Uses the default udp port number in both the “auth_port”
and “acct_port” settings.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS server communication setttings:
DES-3550:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DES-3550:4#
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description
The
config radius delete
command is used to delete a previously
entered RADIUS server configuration.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
