OilFillPlug
Muffler SparkPlug
Shaft Grip Fuel
Cap
Control
D-Handle
Starter
Rope
Grip
Twist & Edge
and Craftsman
ConvertibleTM Throttle
Coupler Controm
Shaft Air Filter
Housing Cover
Line
Cutting
Blade
. AttacC , Sh,e,d
HassieFree TM
Cold
Starting
Lever
Primer
Bulb
INSTALMNG AND ADJUSTING THE D=HANDLE
To Install
1. Place the D-handle down on to the shaft housing and the
bottom clamp so that the handle slants toward the shaft
grip (Fig. 1). Place handle and clamp a minimum of 6
inches from the end of the shaft grip.
On/Off Stop Control
Shaft !
Housing
(4) Screws
Shaft Grip
Minimum 6
(15.24 crn)
Bottom Clamp
Fig. f
2. Start screws with a large Flat-
head or T-25 Torx screwdriver.
Do not tighten until the handle is
adjusted.
To Adjust
3. While holding the unit in the
operating position (Fig. 2),
postion the D-handle to the
location that provides you the
best grip.
4. Tighten the clamp screws evenly,
until the D-handle is secure.
iNSTALL LiNE TRIMMER
ATTACHMENT
NOTE: To make installation easier,
place the unit on the ground
or on a workbench. Fig. 2
1. Turn knob counterclockwise to loosen coupler (Fig. 15, p. 9).
2. While firmly holding attachment, push it straight into the
coupler until the release button snaps into the primary hole
(Fig. 16, p. 9).
NOTE: Aligning the release button with the guide recess (Fig.
16, p. 9) will help installation.
3. Turn the knob clockwise to tighten.
LiNE TRIMMER APPMCATIONS
Cutting grass and light weeds; edging; and decorative
trimming around trees, fences, etc.
