mNSTALLATmON STEP t{)
Elec*rical Requirements
To avoid installation difficulties, do not run the opener
at this time.
To reduce the risk of electric shock, your garage door
opener has a grounding type plug with a third grounding
pin, This plug will only fit intoa grounding type outlet, If
the plug doesn't fit intothe outlet you have, contact a
qualified electrician to installthe proper outleL
TopreventpossibleSERIOUSINJURYor DEATHfrom
electrocutionor fire:
• DisconnectALL electricand batterypowerBEFORE
performingANYserviceor maintenance,
• Garagedoor installationandwiring MUSTbe in compliance
with ALL localelectricaland building codes
• NEVERusean extensioncord,2-wire adapter,or change
plug inanywayto makeit fit out]eL Besuretheopener
is grounded
PERMANF-NT WIRING
CONNECTION
If permanent wiring is required by your local code,
refer to the following procedure.
To make a permanent connection through the 7/8" (2 cm)
hole in the top of the motor unit:
,, Remove the motor unit cover screws and set the cover
aside.,
* Remove the attached 3-prong cord.
° Connect the black (line) wire to the screw on the brass
terminal; the white (neutral) wire to the screw on the
silver terminal; and the ground wire to the green ground
screw.,The opener must be grounded,
° Reinstall the cover,
To avoid installation difficulties, do not run the opener
at this time.
GroundTab
Green
Ground S_ew
Ground Wire Wire
Black Wire
2O
