BaracodaPencil 2 – Communication Protocol v1.3 - 29 -
Data Capture
for Workforce
in Motion
Enable AIM symbology identifier transmission
C
Dissable AIM symbology identifier transmission
C
D
D
on Digits not required but transmitted if read
D
on Digits required and transmitted
D
D
D
D
D
(1): The default minimal length is 6 characters for all symbologies.
(2): This option will not have any effect on symbologies requiring a checksum calculation (EAN/UPC, Code128).
Concerning the symbologies that allow two check digits (code93, code11), the first check digit is obligatory.
Thus, this option will affect the calculation/non calculation of the second check digit.
(3): The default maximal length is 32 characters for all symbologies.
2.4.5.4.
2.4.5.4.2.4.5.4.
2.4.5.4. Special
Special Special
Special Commands
CommandsCommands
Commands
(Type
(Type (Type
(Type "
""
"E
EE
E"
""
")
))
)
Some commands require more than a Boolean digit and require one or more arguments.
Special commands will be used in this case (defined code "E" in type field). It is made of one byte
corresponding to the type of command. Then, depending on the type of command, a certain number
of parameters will be expected. Each of these will be 1 byte long.
This type of command allows the sending of multiple commands in one frame. The Size field must
then specify the total length, in bytes, of the command field.
CODE DESCRIPTION PARAMTER(S) RESPONSE
DEFINE AND ENABLE MIN. LENGTH
DEFINE AND ENABLE MAX. LENGTH
DEFINE AND ENABLE LENGTH FRAME
DEFINE GS REPLACEMENT CHARACTER
GET GS REPLACEMENT CHARACTER
(*): this command will only de effective with ‘A’ header. Otherwise, it will be ignored. Values
accepted for voting are: 2, 3, 4. this command is also unavailable with Pencil2 scanner.
