27
Connecting System Components
Summary
Workflow for Connecting System Components in the Lustre Workgroup
. . . . 27
Connecting the Autodesk Control Surface
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Assigning an IP Address to the Autodesk Control Surface
. . . . . . . . . . . . . . . . . . . 31
Configuring Lustre to Connect to the Autodesk Control Surface
. . . . . . . . . . . . 33
Connecting a Stand-Alone Tablet
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
Connecting the Slave Renderer to a Lustre Workstation
. . . . . . . . . . . . . . . . . . . . 33
Connecting Video I/O to a Master or HD Station
. . . . . . . . . . . . . . . . . . . . . . . . . . . 36
Setting Up VTR Emulation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
Connecting to a High-Speed Data Link Device (HSDL)
. . . . . . . . . . . . . . . . . . . . . 39
Connecting Audio Hardware
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Workflow for Connecting System Components in the Lustre
Workgroup
After you have connected peripherals to your workstation, you are ready to connect it to the
Autodesk control surface, to video I/O hardware, and to a Slave Renderer.
See the following table for a summary of the steps necessary to connect components in your
workgroup.
Step: Refer to:
1. Connect the control surface to your
workstation.
For the Autodesk control surface:
“Connecting
the Autodesk Control Surface”
on page 28,
“Assigning an IP Address to the Autodesk Control
Surface”
on page 31, and
“Configuring Lustre to
Connect to the Autodesk Control Surface”
on
page 33.
2. If necessary, connect a tablet to your
workstation.
“Connecting a Stand-Alone Tablet”
on page 33.
