Introduction
1
10
System ROM Flash was successful appears.
14. Verify system BIOS settings. See “Verifying BIOS Settings” on page 10.
15. From the File menu, select Save Changes and Exit.
Verifying BIOS Settings
You do not normally need to adjust BIOS settings on your workstation. BIOS settings for the
workstation are provided here for informational purposes only.
To enter the system BIOS, press F10 while booting the workstation.
W
ARNING
:
Before installing Red Hat® Linux, it is recommended that you verify the workstation’s
BIOS settings. If the storage SATA emulation option is not set correctly (to Separate IDE Controller),
you must redo Red Hat Linux installation.
The following table lists the proper Autodesk certified BIOS settings. Items not listed are set to
their default factory settings.
Restoring BIOS to Default Factory Settings
The following procedure restores the default factory BIOS settings.
To restore default factory BIOS settings:
1. Press F10 while booting the workstation to enter the system BIOS.
2. From the File menu select Default setup | Restore Factory Settings as
Default.
BIOS Menu Item Value
Storage, Storage options SATA Emulation Separate IDE
Controller
Storage Boot Order Optical Drive
USB Device
Hard Drive,
Integrated SATA
Hard Drive,
Integrated IDE
Storage, Power, OS Power Management Runtime Power
Management
Disabled
Storage, Power, OS Power Management Idle Power Savings Normal
Storage, Power, OS Power Management ACPI S3 Support Disabled
Storage, Advanced, Device Options S5 Wake on LAN Disabled
Advanced Slot5 - PCI 133 Slot5 speed 100Mhz
PCI-x m1
