Select Ring (and Ringer Volume)
✔
To select a personalized
1
Press [ Select ] (while on-hook)
ring
●
Green light goes on
2
Press [
Conference Ring ]
●
Green light next to [ Select ] flutters
●
Current ring pattern plays and repeats every 4
seconds
●
The display shows[ PERSONAL RING #x ] (x will be
a number from 1 to 8)
3
Continue to press [
Conference Ring
] to cycle through all 8
ringing patterns
4
When you hear the desired ringing pattern, press
[
Select ] again
●
Your new ring is set. Light next to [ Select ] goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
begin again. If you lose power after selection you will
also have to select your ring pattern again.
If you select any ringing pattern other than the first one,
outside calls will not be differentiated from inside calls.
To adjust ringer
1
To raise the volume, press the right half of the Volume
volume if necessary
control button labeled [ ▲ ]. To lower the volume, press
the left half of the Volume control button labeled [ ▼ ].
●
If you have a display, it shows
[ RINGER L>>>> H
] (There are 8 possible volume
settings. On the display, 1 arrow is the lowest
setting, and 8 arrows is the highest setting)
26
