32
2. WARNING
Before using the jumpstart, read and follow the instructions
carefully. Also pay close attention to the cautionary
statements on the vehicles battery and any other equipment
you be using.
As a safety measure, there is NO VOLTAGE present at the
clamp ends. The ATD-5900 automatically detects when it is
hooked up correctly to a battery, then and only then will it
deliver the voltage to the clamps.
Do not smoke, use matches, use a cigarette lighter, or allow a
spark or flame near the battery.
Do not all ow metal to come in contact with the battery poles.
It may spark or short-circuit the battery and cause an
explosion.
Remove any and ALL jewelry and watches when working
with a Li-Fe battery.
Stop using the jumpstart when you hear the alarm or when
indicating LED (6) is on. The reason may be from:
1) The voltage is less than 8V - Charge the jumpstart to prevent
battery failure.
2) The temperature is higher than 140ÛF(60ÛC) - Cool the
jumpstart to at least 104ÛF(40ÛC).
3) The jumpstart is connected backwards, incorrectly connected
or short connected. Correctly connect the clamps.
3. Pro-Lithium Jumpstart Features:
1. Emergency LED light Switch
2. Emergency LED light
3. 12V output
4. Full charge LED
5. 50% capacity LED
6. Charge/Low vo ltage alarm/Over-temp indicator
7. Clamp correct connection indicator
8. Reverse connection indicator
9. Incorrect connection indicator
10. USB 5V DC output outlet
11. Test/USB output Switch
12. Charger input outlet
