manufacturer’s instructions
• Be sure that the abrasive product is correctly mounted and
tightened before use. Run the tool at no-load for 30 seconds in a
safe position. Stop immediately if there is considerable vibration
or if other problems are detected. If this condition occurs, check
the machine to determine the cause and, if necessary, change
the abrasive wheel.
• Do not use separate reducing bushings or adaptors to adapt
large holes in abrasive wheels.
• Be sure that the work piece is properly supported
• Do not use grinding or cut-off wheels for side grinding; they
could explode!
• Take care that sparks resulting from use do not create hazards.
Keep observers and flammables well away from work area.
• Always use protective safety glasses and proper hearing
protection. Use other personal protective equipment such as
gloves, an apron, a face shield and/or a helmet when necessary.
• Since there is no brake mechanism in the tool, the wheel will
continue to rotate after the tool is switched off.
