hand and it frees both hands to operate the tool.
Do not strain to reach the work area
Keep proper footing and balance at all times.
Maintain tools with care
Keep cutting tools sharp and clean for better and safer
performance. Follow instructions for lubrication and changing
accessories. Inspect tool cord periodically, and if damaged, have it
repaired by an authorized service facility. Inspect extension cords
periodically and replace, if damaged. Keep handles dry, clean and
free from oil and grease.
Disconnect tools when not in use
Unplug the cord from the electrical socket when not in use, before
servicing, and when changing accessories such as wheels and
guards.
Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting
wrenches are removed from the tool before turning it on.
Avoid unintentional starting
Do not carry a plugged-in tool with a finger on the switch. Be sure
switch is off when plugging in.
Use outdoor extension leads
When tool is used outdoors, use only extension cords intended for
outdoor use.
Stay alert
Watch what you are doing. Use common sense. Do not operate
tool when you are tired.
Check for damaged parts
Before every use of the tool, check for damaged parts carefully to
determine that the tool will operate properly and perform its
intended function. Check for alignment and freedom of movement
in moving parts. Do not use if there is any breakage, slow moving
parts or any other conditions that may hinder its operation. Do not
use the tool if the switch does not function properly. Guards,
malfunctioning switches, or other malfunctioning parts, should be
properly repaired or replaced by an authorized service center
unless otherwise indicated in this instruction manual.
Warning
• The use of any accessory or attachment, other than those
recommended in this instruction manual, may present a risk of
personal injury.
• This electric tool is in compliance with relevant safety
requirements.
• Check that the speed marked on the wheel is equal to or greater
than the rated speed of the grinder.
• Be sure that the wheel dimensions are compatible with the
grinder and that the wheel fits the spindle
• Abrasive wheels should be stored and handled with care and in
accordance with manufacturer’s instructions.
• Inspect grinding wheel before use; do not use chipped, cracked
or otherwise damaged products.
• Be sure that mounted wheels are fitted in accordance with the
