User’s ManualPage 4-28
The underline position is not changed by a Start Subscripting or Start
Superscripting command. If the user would like the underline to follow a
subscript down or follow a superscript up, the original underline command
must be stopped, and a new Start Underline command must be entered
after the subscript or superscript command. This procedure will establish a
new baseline position for the underline.
Underline Stop
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
ww
ww
w
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
N/AN/A
N/AN/A
N/A
This command will stop underlining.
Merge Page Load
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
+M+M
+M+M
+Md
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
N/AN/A
N/AN/A
N/A
The Merge Page Load command is a job boundary command that erases
any previously stored page and stores a new page to be merged with other
pages. A separate command enables the merging of this page with another
to produce a composite page. This command must be used after using
either the Font Load command or the Font Delete command, because
either of those commands will delete the current merge page from memory.
Merge Page Unload
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
+V+V
+V+V
+Vd
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
N/AN/A
N/AN/A
N/A
The Merge Page Unload command is a job boundary command that
erases any previously stored merge page.
Form ID Assignment
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
+#+#
+#+#
+#
formname.formname.
formname.formname.
formname.
FRMFRM
FRMFRM
FRMd
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
0-90-9
0-90-9
0-9
