Setting Up the WAN
50 MM701G User Manual
6 Select Apply to immediately activate the changes that you have made for this session.
7 From the
Main Menu select Save New System Configuration to save these settings or the
changes will be lost upon reboot or power cycle.
8 If you have enabled DHCP, select Reboot from main menu to reboot the router.
SettingUpNAT
This procedure is optional. Follow this procedure to enable or disable NAT for a WAN session.
From the
Main Menu, select WAN Setup to access the WAN sessions page.
1 Select the session for which you wish to enable NAT. The
WAN Sessions Options screen
displays.
2 From the WAN Sessions Options screen, select the NAT option and enter either enable or
disable to change the NAT status for this session.
3 Select
Apply toactivate your changes. Apply immediately activates the changes that you have
made for this session.
4 From the Main Menu, select Save New System Configuration to save these settings or the
changes will be lost upon reboot or power cycle.
• If DHCP Client is selected, you do not need to configure an IP address.
• In Bridge mode, you need an IP address for the LAN port to use a Browser or Telnet
to manage the MM701G.
Session State
1. Disable
2. Enable
Select session NAT (Return to exit) ->
