Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.Item 90018
ATV Loading and Unloading
• Do not use this ramp to load
or unload any vehicle that
weighs more than 1500 lb.
• Do not use this ramp to load
or unload any vehicle that
is wider than the ramp.
• Do not use this ramp to load
or unload any vehicle that is
carrying gear on its racks.
• Do not use this ramp if the
tailgate on the vehicle being
loaded or unloaded is higher than
half the ramp’s length (34").
WARNING: Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing the Ramp to fail.
WARNING! All persons not involved in
the process must stand clear of the Ramp
and truck. Make sure no pets are nearby.
Loading Using a Winch (not included)
1. The winch and mounting/
connection points must all have
appropriate capacity to pull the
ATV up the ramp safely.
2. ATV Mounted Winch Setup: Unwind
cable from the winch and attach it to a
secure mounting location on the truck,
at the same height as the winch will
be after the ATV has been loaded.
3. Truck Mounted Winch Setup:
Attach the cable to the bottom
front part of the frame.
4. While operating the winch, stand
back and to the side of the
ATV, with the vehicle between
you and the winch cable.
5. Operate the winch to slowly load
the ATV onto the vehicle.
Unloading
WARNING! Riding an ATV while unloading
is dangerous and should not be attempted.
1. Have an assistant monitor the Ramp
tongue for slippage on the tailgate.
2. Setup the ramp on the truck bed
as explained under operation.
Remove all tie down straps and
securing equipment from the ATV.
WARNING! Be sure the 4-wheel
ATV is centered on ramp.
3. While staying off the ATV, start
the engine, disengage the parking
brake, put the transmission into
reverse, and make sure the wheels
are in a straight line with the ramp.
While holding the brake, position
yourself in front of the ATV.
4. Release the brake and push on the ATV
to get it started down the ramp. Allow
the ATV to roll down naturally, do not
attempt to steer it or apply the brakes.
If it stops while on the ramp, gently
give it throttle to back it off the ramp.