Filter
Top Products
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 11
Lift and Transfer From Chair
1. Fit sling as described in “Fitting Lumex
Sit-To-Stand Sling”.
2. Push lift towards patient. Open the base of
the lift to go around the chair. Apply the
brakes on both rear casters.
3. Position patient’s feet on the foot platform
and knees against the knee pad.
4. Attached the sling straps to the hooks.
5. Have the patient’s hands holding the handles.
For patients who cannot hold the handles,
have them hold their arms around the chest.
6. Press the “UP” button on the hand control.
7. Before the patient’s body is lifted from the
chair, stop and make sure the sling is secured
and patient’s knees are against the knee pad.
8. The patient should be comfortable with the
pressure under the arms. If not, adjust the sling
and try another loop option to release pressure.
9. Press the “UP” button until the patient’s body
is completely left the chair.
10. Transfer to another object can be done at this
position without the patient attending a full
standing position.
11.Release the brakes, close the base, and pull
the lift away from the chair.
12. Lower the patient to the object intended.
13. To lift patient in a standing position, continue
to lift until the patient’s knees are locked in a
standing position.
14. At the standing position, patient’s knees may
move away from the knee pad.
15. Release the brakes, close the base, and pull
the lift away from the chair.
16. Lower the patient to the object intended.
17. Reverse the above procedures when lowering
the patient to the chair.