Filter
Top Products
LF1050 Patient Lift Owner’s Manual10
OPERATING INSTRUCTIONS
Preparation Before Lifting
1. Turn on the power by twisting the RED RESET
BUTTON clockwise.
Turn off the power by pressing the RESET button.
2. Press the UP or DOWN button on the hand
control once. Check if the battery indicator lights
are on. To proceed with lifting, make sure there
is at least one green light. Batteries are fully
charged when three (3) green lights are shown.
3. After the battery indicator lights go out, push the
UP button and the DOWN button on the hand
control and ensure that the lift is operating
correctly.
4. Position the base of lift around or under
the object.
5. Widen the base.
Lift and Transfer From Bed
1. User/patient should be in the center of the bed.
2. Position user onto his/her side by rolling user
towards you.
3. Roll the sling in half, approximately. The handle
on the back section should face outward when
the sling is fitted.
4. Position the sling under the user/patient so the
commode aperture aligns with the base of the
spine and top of the sling close to the neck.
5. Roll user onto the opposite side and position
him/her on the flat section of the sling. This will
allow you to unroll the remainder of the sling
from the other side of the user.
6.
Once the sling has been positioned centrally,
feed the leg sections under the thighs and draw
them up between the thighs.
7. Raise the head of the bed if this function
is available.
8. Move the lift slowly towards the user and position
the spreader bar over the user's/patient's chest.
9. Attach Loop A of the sling to Hook A on
Spreader Bar; attach Loop B to Hook B; attach
Loop C to Hook C; attach Loop D to Hook D.
10.Lift the user above the bed by using the
hand control.
11.Pull lift away from bed. Position user over the
wheelchair or chair then lower the patient onto
the surface.
Note:
Reverse the above procedures when
returning the user/patient to bed.