Filter
Top Products
1
2
6
7
8
9
10
3
4
5
11
12
PUMP PARTS LIST
ITEM PARTS# DESCRIPTION
1 WWVF FRONT VOLUTE
2 WWIMP IMPELLER
3 UPUFO/R UNION O RING
4 UPUFM UNION MALE 1 1/2"
5 UPUFF UNION FEMALE 1 1/2"
6 PPSSFSEAL SEAL ASSEMBLY
7 PPWWVB VOLUTE BACK
8 PPWWCORD POWER CORD
9 MPASHU506 AIR SWITCH
10 PPWWVO/R VOLUTE O RING
10 UPUFNUT UNION NUT 1 1/2"
12 UNUTEE UNION TEE 1 1/2 X 1 X 1”
CAUTION
To reduce the potential risk of fire, electrical shock, or injury to persons:
1) All electrical wiring (both installation & repair) must be done by a licensed electrician and in accordance with local and state ordinances.
2) No modifications, additions or deletions should be made to the pump, without factory approval.
3) Before starting motor, fill tub with water to level recommended by whirlpool manufacturer. Never run pump dry!
4) Motors have a built-in automatic reset over load protector that guards against damage from mechanical or electrical problems such as
low voltage, locked pump or similar abnormal conditions. Remember, if the timer device is still on, these motors will restart
automatically - as soon as they cool down.
5) Do not relocate pump without prior approval from factory.
WARNING
-- To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
-- To reduce the risk of electric shock, replace damage cord immediately. And Do not use extension cord to connect unit to electric
supply,; provide a properly located outlet.
Pump will not turn on
Pump runs slow.
Pump Humms.
Pump Humms but
Will not turn.
Noisy pump
Pump leaks.
Pump cavitates.
Pump runs but
No jet action.
.
No power to motor
Pump not wired same as voltage supplied
Something stuck in impeller.
Wire not tight..
Pump jammed.
Something in the pump.
Bad bearing.
Hose clamps or union loose.
Bolts holding tank loose.
Leak around shaft from worn seal.
Pump creeps.
Air from jets getting in suction
Air lock.
Check switch and fuse or breaker, also connection from
motor To switch.
Check pump to correct voltage.
Take pump apart and clean impeller( as shown below).
Check terminals.
Remove dust cap and rotate motor shaft with screwdriver.
If unable to turn, send in for repair.
Take pump apart and remove debris.
Replace Bearing.
Tighten.
Tighten
Replace shaft seal.
Secure pump to floor.
Direct directional flow fitting away from suction fitting.
Turn pump on, wait 10 seconds. Turn pump off.
Repeat up to 10 times. If airlock is not cure, try turn tee
union
#12) as shown in clock-wise and tighten back.(Do not turn
all
The way)
SYMPTOMS PROBABLE CAUSES RECOMMENDED ACTION
TROUBLE SHOOTING GUIDE
14