Filter
Top Products
10
Plumbing Connections
All plumbing connections should be made by a qualified, licensed plumber in accordance with local
plumbing and building codes.
Hot and Cold Water Supply Lines
Connect 1/2” ID supply tubes to a fresh water source. Shut-off valves should be utilized.
Electrical Connections
The Foot spa must be plugged into a GFCI protected outlet, installed by a licensed electrician.
Testing the Foot spa
Clean the tub and fill with water to the wave-mark (water level) on the wall of the tub.
When the tub is filled with water, turn the switch on the front of the pedicure spa to activate the
whirlpool pump. Water should be coming out of the jets and the Air Bleed spout. Check for whirlpool
leaks. After checking under the tub for leaks, use the same switch to turn the whirlpool pump off
and drain the tub basin by opening the overflow/waste control handle and turning on the Power
Drain Pump if installed.
Cleaning and Care of Your Foot spa
Between Each Customer
• Drain all water and remove debris from the pedicure spa.
• Clean the surfaces and walls of the Foot spa with soap or detergent and rinse with clean, clear
water
• Disinfect with an EPA-registered disinfectant.
• Wipe out with a clean towel.
Flushing of the Whirlpool System
Caution: J&A USA requires that the pedicure spa be thoroughly cleaned after every 10th pedicure
and after the last pedicure of the day. It is extremely important to flush the whirlpool system of
the Foot spa to prevent harmful bacteria from growing and to prolong the life of your pedicure spa.
• Remove the Suction Fitting Cover with a phillips screwdriver
• Scrub the suction cover with a chlorine bleach solution of 1 (one) teaspoon of 5% chlorine bleach
to 1 gallon of water, or
• Totally immerse the suction Fitting cover in an EPA-registered disinfectant and scrub.
• Replace the Suction Fitting Cover with a screwdriver. Do not over tighten the mounting screw.
• Do not run the pedicure spa whirlpool jets without the Suction Fitting Cover in place.
• Fill the tub basin near the wave mark on the rear wall with hot water.
• Turn the whirlpool jets on.
• Add 3 (three) teaspoons of low foaming “crystal” dishwasher detergent and 2 (two) ounces of
household bleach to the tub basin.
• Run whirlpool for 10-15 minutes and drain the tub basin.
• Fill the tub basin near the wave mark on the rear wall with cold water.
• Run the whirlpool jets for 5 minutes and drain the tub basin.
• Clean the pedicure spa with a soft cloth and a mild detergent.
Weekly Disinfecting Procedure of the Whirlpool System
• After following the outlined procedures for daily cleaning, fill the pedicure spa tub with hot water
and 4 (four) teaspoons of 5% bleach solution.
• Circulate the solution through the whirlpool system for 5-10 minutes.
• Let the solution sit overnight (at least 6-10 hours).
• The following morning (before the first customer) run the foot spa for 5 minutes and drain.
• Follow the procedure “Flushing of the Whirlpool System”.