Filter
Top Products
22 Welch Allyn Spot Vital Signs
Quick Reference/Error Code Card
The Quick Reference/Error Code Card should be attached either to the Spot Vital Signs
handle, the Mobile Stand, or the Wall Mount.
AC Power Connection
Use the Spot Vital Signs with AC or battery power (after charging the battery).
1. Insert the round transformer connector into the AC power connection port on the left
of the Spot Vital Signs (see page 18).
2. Insert the line cord into the line connector on the transformer then plug the power
cord on the transformer into the AC main power source to charge the battery.
Charging the Battery
CHARGE THE BATTERY FOR SIXTEEN (16) HOURS PRIOR TO INITIAL USE.
Attach the AC power transformer to the Spot Vital Signs then plug the transformer into
the AC main power source.
While charging, the charger icon remains on and the battery icon segments continuously
sequence. When the battery is fully charged, all battery icon segments display.
As the battery voltage level drops the segments turn off from left to right. If the Spot Vital
Signs is not plugged in to charge when the second last segment is turned off the Spot
Vital Signs issues a warning beep. As the voltage level drops to compromise
measurements an error beep is heard and all other display fields turn off. Spot Vital Signs
beeps at increasingly frequent intervals until it finally powers itself off.
If not used for extended periods of time then recharge the battery.
Standby Mode
When the device is powered up, but has not been used for 2 minutes, it goes into
Standby Mode. “Z Z Z” appears across the top of the display with no backlight. Standby
Mode conserves battery power.
To bring the Spot Vital Signs out of Standby Mode, press the Mode or Pressure Preset
button or begin a patient measurement.