Filter
Top Products
3
Installa
Installa
tion
tion
Preparation-Mains Supply ●
Preparation-AV Connection ●
WARNING!
High voltages are used in the operation of this set.
Refer service to qualified service personnel.
☞ Connect the power cord of the monitor to a wall outlet.
✐ The monitor is prepared for a mains voltage AC220~240V
50Hz. When the monitor is not to be used for an extended
period of time, it is advisable to disconnect the power cord
from the power outlet.
Mains Supply
AV Connection
AC Mains Outlet
Important:
This equipment is fitted with an approved non rewireable UK
mains plug.
To change a fuse in this type of plug proceed as follows:
1. Remove the fuse cover and fuse.
2. Fix a new fuse which should be a BS1362 5Amp A.S.T.A.
or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place. If
the mains plug contains a fuse, this should have a rating of
5Amp. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5Amp.
Note: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13Amp
socket elsewhere.
The wires in this mains lead are coloured in accordance with
the following code:
Blue -------> Neutral
Brown ----> Live
1. The Blue wire must be connected to the terminal which is
marked with the letter “N” or coloured BLACK.
2. The Brown wire must be connected to the terminal with
the letter “L” or coloured RED.
3. Do not connect either wire to the earth terminal in the
plug which is marked with the letter “E” or by the earth
symbol or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the wires.
Terminal Description
VIDEO IN BNC connector for video in.
VIDEO OUT BNC connector for video out.
AUDIO IN RCA connector for audio in.
AUDIO OUT RCA connector for audio out.
VIDEO IN
AUDIO OUT AUDIO IN VIDEO OUT
ANT.75