Filter
Top Products
9
Job#: XXXXXXX Title: CWST2RB Manual
Date: 10/15/09 Version: CWST2RB-MAN-Rev11
Operating Instructions
Proper Use Operations
Note:
• For best results, remove all make-up and wash your
face with a neutral pH cleanser.
• During use, hold the device in a single location until
the cycle is complete.
Step 1: To ACTIVATE, press the Power Button until
the device beeps once, indicating that the care
cycle is ready to begin.
Step 2: Apply protective eyewear (goggles). Place
over cotton balls for added comfort.
Step 3: To START, place the device against the
desired area of your skin to receive care. The
LED lights will turn on and the cycle will begin
once the device is in full contact with your skin.
Step 4: Hold device fi rmly in place until the device
beeps twice signaling that the care cycle
is complete. Do not move the position of
the device on your skin. Device will beep if
removed from skin — see page 10. If battery
runs low and shuts off unit, plug AC Adapter
directly into device and continue care cycle.
Step 5: Replace the ClearWave
®
Soothing Skin
System to the Charging Stand to fully charge
for the next treatment.
Note: To manually turn OFF the ClearWave Soothing
Skin System prior to the end of a cycle, press and
hold the Power Button for approximately 3 seconds
until the device beeps twice.
Note: Device can be used when connected directly
to the AC Adapter. See page 11.
Step 1
Step 2
Step 3
Step 4
Step 5
The daily care regimen is the same for both interchangeable heads. When
using the ClearWave Soothing Skin System, care for each desired area of
the skin for the 3 minute cycle. You may care for a particular area up to a
maximum of 15 minutes (5 cycles) in a 24 hour period. For optimal results,
allow 24 hours before your next care cycle.
Daily Care for Your Skin