Filter
Top Products
13. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
13- 1
13. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
How to access REG., M.DOWN, or REWRAP menu
(1) Turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the key.
(3) Should a power failure occur during operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(4) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(5) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point
by depressing the key.
(6) Check the date of the scale before operation every day.
(7) Make a test print before operation every day.
Press the key, and the test label is issued.
ZERO
TEST
POWER
The following display is the REG. menu display. When this display is shown after pressing
the key, you can start the REG. operation right away.
POWER
<REG.> MANU. WEIGH
ENTER THE PLU #
NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to
Section 10.11 and press the key.
SET NEXT
To access a menu from other menus, press the key to show the Main menu and
enter the menu No. When the M.DOWN and REWRAP menus are protected, enter the
menu No. and then the password.
<Menu>
0. PROG. 5. REPORT
1. REG. 6. RESET
2. MARK DOWN 7.
3. REWRAP 8.
4. SECURITY 9.
ESC.
lb UNIT/$ TOTAL $
0.000 P 000000
Do not exceed the platter weight of maximum capacity. Or hang any item from the scale which
exceed the platter weight.
WARNING!