Toshiba SL-9000N-FFH-US Scale User Manual


 
10. PROGRAMMING PROCEDURES
10.13 CMT/PL-3
10-21
PL-3 Operation
Error Code Error Message
0 FDC ERROR
1 FDK MISINSERTION ERROR
2 UNAVAILABLE FDK INSERTION
ERROR
3 VOL. LABEL UNMATCH ERROR
4 FDK MEMORY FULL ERROR
5 WRITE PROTECT ERROR
1
6 NO SEARCH FILE ERROR
1 TIME OUT ERROR
2 LOAD ERROR
3 FDK ERROR
4 BUSY STATUS
5 POWER FAIL ERROR
3
6 OVERRUN ERROR
Error Code Error Message
7 FRAMING ERROR3
8 PARITY ERROR
0 DATA ERROR
1 STATUS ERROR
2 TIME OUT ERROR
3 FDK READ/WRITE ERROR
7
F DESIGNATED SELECT KEY
ERROR
0 RAM READ/WRITE ERROR
1 ROM CRC ERROR
2 RAM BACK UP BATTERY ERROR
3 FDC DIAG LEVEL 0 ERROR
E SYSTEM FDK LOADING ERROR
8
F SYSTEM ERROR
NOTES:
1. Press or key on the PL-3.
2. In the event Enter Key is not pressed within 10 seconds after or key is
pressed, the Time Out Error results.
3. After pressing the key, the operation ends when 00 appears in the 7 seg. display
and LAMP goes off. Remove the data disc and turn the power off.
4. Be sure to start the PL-3 before the main operation.
Connect the PL-3 to the SL-9000 by using RS-232C Cable, then turn on the power of the SL-9000
and the PL-3.
Insert a data disc into the PL-3 and adjust the transmission rate to the SL-9000 ( :4800
BPS or : 2400 BPS) by using the rotary switch.
Press the key of the PL-3, then check whether the SAVE LED is on.
Program the file number of the data disc by using the rotary switch.
( : File No. 1, : File No. 2, ....... : File No. 8, : File No.9)
7
2
7
3
SAVE
4
1
4
2
4
8
4
9
2
<MENU>
Page 2
PROG.
ESC.
<MENU>
Page 2
Main
<MENU>
Set the transmission item.
(Refer to table 4)
SAVE
LOAD
or
NEXT
PLU
or
ENTER
SAVE
LOAD
SAVE
LOAD
ENTER
Table 3: Error code during PL-3
operation
1) When the error code is FF, this system enters stop mode. (Turn the power off/on for
release.)
2) When the error code is F2 or FE, perform the status clear ( ).
3) If an error occurs, refer to the PL-3 Owners Manual and solve the problem.
9 9