Filter
Top Products
2. SPECIFICATION
2.2 OPTION
2-2
2.2 OPTION
Option Name
Model No.
or Part No.
Description
Source
LON Connector
TM8P-88P
Part No.
EAJ-0028001
A modular connector used to connect scales
to each other in a LON configuration.
See
Note 2
LON Terminal
Resistor 285D-8P
Part No.
EAJ-0029001
A modular resistor attached to the scales
connected at both ends of the LON
configuration.
See
Note 2
LON
LON Cable
S-STLAN-2P
(200 m/roll)
Part No.
10319100003
An 8-pin telephone cable used with the LON
connectors attached to both ends of the
cable. This cable connects scales to each
other in a LON configuration.
See
Note 2
I/O PC Board
OP-9000-IOB An I/O board equipped with the TMCC
interface. It is used to construct a TMCC
system.
See
Note 1
TMCC
TMCC Cable kit
OP-9000-IOCN-
TMCC
A cable kit for the TMCC interface.
See
Note 1
MEMO PC Board
(SL-9000 only)
OP-9000-
PIGGYBACK
OP-9000-
PIGGYBACK-S/F
This board is used to expand the PLU
memory to 4MB by installing the memory
module.
See
Note 1
OP-9000-RAM-
512KB
DIP type PS-RAM to be installed on the
MEMO PC board (OP-9000-PIGGYBACK) for
memory expansion. When expanding the
memory, install the two modules as one set.
Memory Module
OP-9000-SRAM-
512KB
DIP type S-RAM to be installed on the MEMO
PC board (OP-9000-PIGGYBACK-S/F) for
memory expansion. When expanding the
memory, install the two modules as one set.
See
Note 1
and 3
Power Cord
---------- Please locally purchase a power cord of
proper length for the installation location.
Power cord shall be a standardized article of
each destination.
See
Note 1
10 Base T (LAN) Interface
Board (SL-9000N only)
OP-9000N-LAN This board enables the SL-9000N to be used
in a LAN network.
See
Note 1
LAN Cable Kit (SL-9000N
only)
OP-9000N-LAN-
FFH
This kit is required when installing the OP-
9000N-LAN (LAN Interface Board) on the SL-
9000N-FFH.
See
Note 1
NOTES:
1. Contact TOSHIBA TEC H.Q. or your nearest TOSHIBA TEC representative.
2. Order from TOSHIBA TEC Parts Center or purchase locally.
3. When purchasing memory modules locally, select one having the following specifications.
Maker: HITACHI Pseudo Static RAM (OP-9000-RAM-512KB)
HITACHI Static RAM (OP-9000-SRAM-512KB)
Type: HM658512ALP-8V 80 ns, 600 mil 32-pin Plastic DIP (DP-32) (OP-9000-RAM-512KB)
HM628512ALP-770ns, 600mil 32-pin Plastic DIP (DP-32) (OP-9000-SRAM-512KB)
4. The MEMO PC Board (with Flash ROM) is installed in the SL-9000N model as standard.