Filter
Top Products
7-1
7. INSTALLATION PROCEDURE
7. INSTALLATION PROCEDURE
7. INSTALLATION PROCEDURE
Remote Display
Connector Cover
1. To install the remote display, insert the two screws on the bottom of the remote pipe into the holes
provided on the scale base.
2. Connect the connectors, pull down the connector cover, and install the remote blind plate.
Then tighten the screws to secure the remote display.
3. Remove the tape from the remote packing and remote cap and lower to fit them to the scale.
Remote Display
Remote Pipe
Remote Cap
Remote Packing
Tape
Screw
Hole
Screw
Remote Blind Plate
Connector
Connector
WARNING!
Be sure to cover the connectors with the connector cover because of high voltage and current.
If the connectors are exposed to water, a leakage may result.
CAUTION: Never place the scale upside down. Doing so will cause a malfusction.