Toshiba SL-47-N Scale User Manual


 
EMl-3106lA
1. INTRODUCTlON
I. INTRODUCTION
1. INTRODUCTION
We thank you very much for purchasing the TEC Digital Scale SL47-N-1 Series. This series has
been designed with TEC reliability.
Should you have any questions concerning the scale, please refer to this manual. Be sure to keep
this manual for future reference.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operations of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
(for USA only)
Changes or modifications not expressly approved by manufacturer for compliance could void the user’s
authority to operate the equipment.
“This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.”
“Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel
brouilleur du Canada.”
(for CANADA only)
I
WARNlNG
This is a Class A product.
In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
I
As the colours of the cores in the mains lead of this equipment may not correspond with the colour
markings identifying the terminals in your plug, proceed as follows:
l
the core which is coulored green and yellow
must
be connected to the terminal in the plug
which is marked with the letter E or by the earth symbol, or colored green and yellow,
l
the core which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
l
the core which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.
This equipment must be earthed.
Safety Summary
Personal safety in handling or maintaining the equipment is extremely important. Warnings and
Cautions necessary for safe handling are included in this manual. All warnings and cautions contained
in this manual and written inside or outside of the scale should be read and understood before handling
or maintaining the equipment.
Do not attempt to effect repairs to this equipment.
If a fault occurs that cannot be rectified using the
procedures described in this manual, turn off the power, unplug the machine, then contact your
authorised TEC representative for assistance.
l- 1