Filter
Top Products
3-1
Chapter 3
Installation
3-1 Hardware Installation
User the directions below to install the AOC-R1UG-IBQ add-on card into your system.
Before Installation
Before Installation, do the following
1. Power down the system.
2. Remove the power cord from the wall socket.
3. Use industry standard anti-static equipment (i.e. gloves or wrist strap) and/or an
environment that prevents accidental electrostatic discharge.
4. Familiarize yourself with the server, motherboard, and/or chassis documentation.
5. Confirm that your Operating System includes the latest updates and hot-fixes.
Installation
The AOC-R1UG-IBQ add-on card can beinstalled directly into both the SBX connector
and PCI-E 2.0 x8 (in a x16) slot onto the H8DGG-QF serverboard. Position the add-on
card in both the PCI-E slot and over the SBX connector and gently push down on both
sides of the card until it slides into the PCI-E connector and SBX connector together.
Installing the Add-on Card
1. Remove the server cover and, if necessary, set aside any screws for later use.
2. Remove the add-on card slot cover. If the case requires a screw, place the screw
aside for later use.
3. Position the add-on card in both the PCI-E slot and over the SBX connector and
gently push down on both sides of the card until it slides into the PCI-E connector
and SBX connector together.
4. Secure the add-on card to the chassis. If required, use the screw that you previously
removed.
5. Replace the chassis cover.
6. Connect the incoming QSFP cable to the QSFP port provided on the card.
NOTE: This card is designed for the H8DGG-QF serverboard only.