Sunrise Medical Z-500 Mobility Aid User Manual


 
930578 Rev. B
X. Operating Guide
35
B. QTRONIX PROGRAMMING PAD (OPTIONAL)
Program settings beyond the ability of the rider
can result in serious injury. Consult your health
care advisor before you alter settings.
1. Notes:
The Qtronix Programmer lets you adjust the control
settings of the Z-500. You can customize a program for
yourself or select the standard program.
acceleration rate
deceleration rate
turn acceleration
turn deceleration
forward speed (max & min)
reverse speed (max & min)
turn speed (max & min)
steer correct
4-axis joystick throw
sleep timer
2. To Program Your Chair:
a. Turn off power to the chair.
b. Insert Qtronix Programmer plug (A) into the
Programmer/Charger socket on the front of the
remote joystick.
c. Turn
on power to the chair; program
as needed.
d
.
Rem
ove plug and cycle ON/OFF switch to drive
chair.
NOTE– Review the Qtronix Programmer Owner’s Manual
for more details on how to program your chair.
IX. Set-Up, Adjustment & Use
930578 Rev. B
34
O. STRUT TUBES
1. Width Adjustment
a. Replace the three strut tubes and release bar with
larger or smaller sizes. Strut tubes and release
bars are available from your authorized supplier.
NOTE ON WIDTH ADJUSTMENT– Size changes may
require a larger seat insert and footplates. 15" and 16"
widths receive adult hangers.
P. CHECK-OUT
After the wheelchair is assembled and adjusted, it
should roll smoothly and easily. All accessories should
also perform smoothly. If you have any problems,
follow these procedures:
1.Review Set-up, Adjustment & Use sections to
make sure chair was properly prepared.
2.If your problem persists, contact your autho-
rized supplier. If you still have a problem after
contacting your authorized supplier, contact
Sunrise customer service. See the introduction
page for details on how to contact your autho-
rized supplier or Sunrise customer service.
A
A. PERFORMANCE CONTROL SETTINGS
1. It is vital to match control settings to your level of function and ability.
2. Consult your health care professional and your supplier to select the best control
settings for you.
3. Check and adjust the settings every six to twelve months (or more often, if needed).
4. Adjust the control settings
immediately if you notice any change in your ability to:
•Control the joystick.
•Hold your torso erect.
•Avoid running into objects.
5. Control Settings are adjusted through the use of the Quickie QTRONIX Programmer.
See your supplier if you do not own a Quickie QTRONIX Programmer pad.