Filter
Top Products
33
930485 Rev. A
E. INTEGRAL JOYSTICK
The standard integral joystick controls the
chair’s performance. It consists of the follow-
ing parts:
1. Speed Control or Drive Mode
Selection Buttons (A and B)
To decrease the speed level depress button
A. Or, when 1- 5 Drive modes are pro-
grammed, depress button A to activate lower
drive mode(s).
To increase speed level, depress button B. Or,
when 1- 5 Drive modes are programmed,
depress button B to activate higher drive
mode(s).
Speed level active, or Drive Mode selected, is
indicated on display (C) by a series of five
lights. One light indicates slowest level/mode
currently active, while five lights indicates
highest level/mode currently active.
2. Battery Charge Indicator (D)
• Green lights indicate that batteries are
fully charged.
• Yellow lights indicate that batteries
need recharging.
• When the lights stay in the red band,
the batteries must be recharged.
3. On/Off Button (E)
Turning the chair on or off is accomplished by
depressing button E.
4. Horn (F)
5. Joystick (G)
The joystick controls the direction and speed
of your chair.Turn the chair on and move the
joystick in the direction you want to go.
• Moving the joystick from the neutral
(center) position disengages the motor
locks, allowing the chair to move.
• The chair will move faster the more you
move the joystick away from neutral.
X. OPERATING GUIDE
32
930485 Rev. A
X. OPERATING GUIDE
C. THERMAL ROLL-BACK
Your chair has a thermal roll back circuit.
This protects the controller from damage
due to overheating. In extreme conditions
(such as repetitive hill climbing) the circuit
will decrease the power to your motors.
This allows the chair to operate at a
reduced speed.When the controller cool,
the chair will return to normal speed.
D. CIRCUIT BREAKERS
1. Notes:
Your Quickie V-521 has two styles of
battery box; Single (one circuit breaker)
and Dual (two circuit breakers, one on
each box)
• In the unlikely event of a short circuit
or heavy overload, all power to your
chair will be shut off.
• To reset your chair,depress the circuit
breaker button(s) on the battery box
lids.A few minutes wait is required
before the circuit breaker(s) will reset.
2. Repeated Shutdown:
If the chair continues to shut down
after resetting,have it serviced by
a supplier.
A
D
F
E
G
H
B
C
Integral Joystick