Filter
Top Products
28
29
930485 Rev. A
930485 Rev. A
IX. SET UP, ADJUSTMENT & USE
1. Installing Armrest
a. Insert front and rear posts into arm-
rest receivers.
b. Engage levers (A and B) to secure
armrest.
2. Set-up for Flip-back Operation
a. Disengage lever (A) so front post
is able to come free.
b. Armrest now has the ability to be
flipped back without removal.
3. Set-up for Removal
a. Disengage levers (A and B) so front
and rear posts are able to come free.
b. Armrest can now be easily removed
for transferring.
4. Height-Adjustment (option)
a. Release the upper securing lever (C).
b. Set at desired height
c. Return securing lever to locked
position.
d. Move armrest up or down to allow
armrest to snap into place
K. HEIGHT-ADJUSTABLE
ARMRESTS (OPTIONAL)
1. Installation
a. Slide the outer armpost into the
receiver mounted to the wheelchair
frame.
b. The armrest will automatically lock
into place.
2. Height Adjustment
a. Rotate release lever to second stop.
b. Slide armrest pad up or down to
desired height.
c. Return lever to locked position
against armpost.
d. Push arm pad until upper armpost
locks firmly into place.
3. Removing Armrest
a. Rotate release lever to first stop and
remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked posi-
tion against armpost.
IX. SET-UP, ADJUSTMENT & USE
G. ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest
(ELR) see instructions for Swing-away
Footrest installation page 29.
2. Adjustment
a) To raise legrest,lift to desired position.
Legrest will automatically lock in place.
b) To lower legrest, while seated in chair,
first lift slightly then press release
lever (F) down and lower legrest to
desired position.
H. INTEGRAL JOYSTICK
INSTALLATION
1. To Connect
a. Connect left and right motor to respec-
tive motor plug.Align ridges (A).
b. Connect battery plug to battery box.
Refer to wire diagram.
2. To Disconnect
Pinch lower edges of plug to release barb
mechanism (B). Pull apart.
I. JOYSTICK SWING-AWAY
RETRACTABLE MOUNT
(OPTIONAL)
The joystick is mounted with a mechanism
which allows the control to be locked in a
forward or retracted position using magnets.
Adjustment
a. To retract joystick,push outward on
the inside of joystick.
b. Push joystick away from front of arm-
rest until it locks into retracted position.
c. To return to forward position, push
joystick forward until it locks into
place.
J. DUAL-POST HEIGHT-
ADJUSTABLE ARMRESTS
The dual-post flip-back armrest can be used
as either a flip-back armrest or a removable
armrest.
F
C
A
B
C
A
B
Height-Adjustable
Armrest Key
1. Outer armpost
2. Standard receiver
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Outer armpost tension
adjustment set screws
8. Inner armpost
9. Receiver adjustment bolts
10.Release Lever
1
10
6
7
8
4
3
5
9
2