Filter
Top Products
32
33
930356 Rev.B930356 Rev.B
M. WHEEL LOCKS
Quickie T45 wheelchairs are standard
with wheel locks. Wheel locks are
installed by Sunrise unless you have
requested otherwise.
Note: Use a torque setting of 100 in./lbs when
setting-up wheel locks.
1. Adjustment
a. Loosen the screws on the side of each
clamp. Do not attempt to remove one
screw at a time.
b. Slide assembly toward rear wheel until
clamp embeds into tire to prevent wheel
movement,when in locked position.
c. Adjust angle to position.
d. Tighten screws.
N. CHECK-OUT
After the wheelchair is assembled and
adjusted, it should roll smoothly and easily.
All accessories should also perform
smoothly.
If you have any problems, follow these
procedures.
1. Review the set-up and check-out sec-
tion and operating guide to make sure
chair was properly prepared.
2. Review troubleshooting guide.
3. If your problem persists,contact your
authorized supplier. If you still have a
problem after contacting your autho-
rized supplier, contact Sunrise cus-
tomer service. See the introduction
page for details on how to contact
your authorized supplier or Sunrise
customer service.
IX. SET UP & ADJUSTMENT
IX. SET UP & ADJUSTMENT
K. FIXED/ADJUSTABLE BACKREST
The backrest comes with an angle-adjust-
ment range from 16
o
to 40
o
.
1. Angle-Adjustment
a. Loosen and remove bolt (a)
b. Set backrest at desired angle using pre-
set holes in armrest angle plate.
c. Replace and tighten bolt.
d. Repeat on other side.
Important Note: The adjustment on each side
of the chair should be exactly equal.
2. Depth Adjustment
a. Loosen bolts (b) from front and rear
linkages.
b. Remove bolt.
c. Reposition linkages on seat frame.
d. Replace bolts and tighten.
L. STROLLER HANDLES (Optional)
1. Installation
a. Press button (a) on the stroller handle
so that release pins are drawn inside
the tube.
b. Insert the tube into the back tube
receiver (b) and the release pin is
through the receiver mounting hole.
a
b
a
b