Filter
Top Products
28
29
930356 Rev.B930356 Rev.B
F. DUAL-POST, HEIGHT-
ADJUSTABLE ARMRESTS
1. Installation or Removal
a. The assembly is held securely in place
when the lever (a) is facing forward.
b. Pull back on securing lever.
c. Insert or remove armrest.
d. Return securing lever to locked position.
2. Height-Adjustment
a. Release the upper securing lever (a).
b. Set at desired height.
c. Return securing lever to locked position.
d. Move armrest up or down to allow
armrest to snap into place.
G. ADJUSTABLE LOCKING FLIP-
UP ARMRESTS (Optional)
1. Adjustment
a. Loosen clamp bolts (a) and (b).
b. Move clamp and bushing up or down
backrest posts to desired position.
c. Tighten bolts.
d. Repeat the process for the other
armrest.
2. Angle-Adjustment
a. Loosen bolt (b).
b.Set armrest at desired angle using pre-
set holes in armrest angle plate.
c. Tighten bolt.
IX. SET UP & ADJUSTMENT
a
b
a
IX. SET UP & ADJUSTMENT
C. ARTICULATING LEGREST
(Optional)
1. Installation
To install or remove Articulating Legrest
(ALR) see instructions for Swing-Away
Footrests installation.
2. Adjustment
a. To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b. To lower, while seated in chair, press
release lever (a) forward and lower
legrest to desired position. Legrest
will automatically lock in place.
D. ELEVATING LEGREST (Optional)
1. Installation
To install or remove Elevating Legrest
(ELR) see instructions for Swing-Away
Footrests installation.
2. Adjustment
a. To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b. To lower, while seated in chair, press
release lever (b) forward and lower
legrest to desired position. Legrest
will automatically lock in place.
E. CASTERS
1. Installation
a. Remove dust cover (a) from caster
housing. Pry dust cover off using a
back and forth motion.
b. Caster assembly holds one nut (b)
and one washer (c). Remove nut
and washer.
c. Insert caster stem (d) into caster
housing (e) and place washer on stem.
d. Replace nut on caster stem and tighten
until all play is removed; then loosen
approximately 1/8 turn, yet still allow-
ing for free rotation.
e. Replace dust cover to caster housing.
a
b
a
b
c
d
e