Filter
Top Products
930705 Rev. B
G. SEAT HEIGHT ADJUSTMENT
(Figure 11)
1. Remove pins from seat mount post.
2. Unscrew set screw.
3. Select the desired seat height (rear seat mount should never be more then one
position lower then the front).
4. Reinsert the pins.
5. Tighten set screw.
H. SEAT REMOVAL
1. Remove Seat
a. Unplug controller connections at the back of the seat.
b. Loosen seat mount screw.
c. Pull the seat forward and remove.
d. When replacing the seat into the mounts, ensure you do not pinch your fingers.
Always replace the safety lock-out pin to prevent inadvertent release of the seat.
2. Seat Post Storage (Garnet only)
(Figure 12)
During transportation the seat adjustment post can be removed from the seat receiver (A)
and stored in a transportation receiver (B).
I. CHECK-OUT
Once the wheelchair/scooter is assembled and adjusted, it should roll smoothly and easily.
All accessories should also perform smoothly.
After the wheelchair/scooter has been set up be sure the chair/scooter performs to your
specified operational settings (see Operating Guide). If the chair/scooter does not perform
to specifications, turn the wheelchair/scooter OFF immediately and reprogram operational
specifications using the QTRONIX Programming Pad.
Repeat this procedure until the wheelchair/scooter performs to specifications before
attempting active use of the wheelchair/scooter.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure
chair/scooter was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
IX. Set-Up, Adjustment & Use
23
English
11
12
A
B