Filter
Top Products
IX. SET-UP, ADJUSTMENT & USE
NOTES:
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair/scooter. This
makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair/scooter are special high-strength fasten-
ers and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loosening.
1. Use of improper fasteners may cause the chair/scooter to fail.
2. Over- or under-tightened fasteners may fail or cause damage to parts.
3. If bolts or screws become loose, tighten them as soon as you can. Loose
bolts or screws can cause damage to other parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassemble
parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque
wrench that measures 120 inch-pounds to secure screws, nuts and bolts on this
chair/scooter.
NOTE– Unless otherwise noted, use a torque setting of 120 inch-pounds for all fasteners.
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair/scooter you will need the following tools:
• 3mm Allen Wrench
• 5mm Allen Wrench
• 6mm Allen Wrench
• 8mm Allen Wrench
• 13mm Open-end Wrench
• Phillips screwdriver #2
• 17mm Socket Wrench
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair/scooter yourself, Sunrise recommends that
you use a torque wrench.
NOTE– The wrench must measure inch-pounds. You can buy a torque wrench and proper sockets from a
hardware store.
CHECK-OUT (Ruby/Ruby 11 only)
Be sure this chair/scooter performs to your chosen operational settings. If it does not, turn
the chair/scooter off immediately and reprogram with the Quickie QTRONIX Programmer. if
you do not own a Quickie QTRONIX Programmer have your supplier reprogram your wheel-
chair/scooter as needed. Or, you can order a Quickie QTRONIX Pad for your own use, from
your supplier.
NOTE– Repeat this procedure until the chair/scooter performs to your specifications.
When properly set up, this chair/scooter will operate smoothly. Check to see that
all components work properly. If you detect a problem, be sure to correct it
before use.
930705 Rev. B
20
English
IX. Set-Up, Adjustment & Use