Filter
Top Products
Issue 4 14
Adjustable speed setting
Your controller has five speed
settings.
To adjust:
1. Press the mode button until the
speed settings indicator is
flashing (Fig. 14).
2. Increase or decrease the speed
setting by pushing the joystick to
the left or right respectively, until
the required setting is obtained.
To activate the setting either
push the joystick forwards to
drive or press the mode button
until the flashing lights are no
longer flashing.
3. When the third or middle speed
indicator light is selected on a
10 km/h chair the vehicle is set
at 4mph. Please note that this
is the maximum speed
permitted for pavement use.
Battery level indicator
This has ten colour coded lights,
3 red, 4 orange, and 3 green, and
denotes the state of charge of the
batteries (Fig. 15). Green is high,
Orange is low, and Red is
dangerously low. The most
accurate reading is attained when
the chair is stationary and on a
level surface. The lights also help
indicate the position of a fault
(should the need arise). When in
fault the light will flash quickly.
Noting the number of lights flashing
may help your service agent in
simple fault finding.
Fig. 14
The Penny and Giles Pilot + control pod
Fig. 15
Adjustable speed
setting indicator
showing 4mph mode