Filter
Top Products
13 Issue 4
The Penny and Giles Pilot + control pod
Fig.12
Fig.13
Power supply
Ensure the power lead is
connected correctly into its socket
on the rear of the control pod
(Fig.12).
The immobiliser plug
When this is activated the chair will
not function, other than the hazard
warning light system. This may be
useful if you wish to leave your
wheelchair unattended (Fig.12).
To activate the immobiliser
1. Switch the chair on via the On/
Off button (Fig.13).
2. Insert the immobiliser plug into
the charger/programmer socket
located on the front of the control
pod.
3. Remove the plug after 1-2
seconds.
4. Your chair should now be
immobilised.
To de-activate the immobiliser
1. Switch the chair on via the On/
Off button.
2. Insert the immobiliser plug into
the charger/programmer socket
located on the front of the control
pod.
3. Remove the plug after 1-2
seconds.
4. Your chair should now be ready
to use.
Immobiliser
plug
Charger
programmer
socket
On/Off
button